Semtech SX1308 IMLTRT Indoor Micro Gateway Digital Baseband Chip
更新時間: 2020-12-11 14:50:14
Semtech SX1308 is a digital baseband chip mainly used for indoor LoRaWAN pico gateways, with a sensitivity of -139dBm and dynamic data rate adjustment (ADR). The SX1308 digital baseband chip is a huge digital signal processing engine, specially designed to provide breakthrough gateway functions in the ISM worldwide, and integrates LoRa concentrator IP.
Functional block diagram:
SX1308 generally connects two SX1257 (or SX1255). SX125x is a radio frequency front-end chip, which is responsible for converting I/Q (In-phase / Quadrature, in-phase quadrature digital signals) into radio analog signals.
2x SX1257 radio front end supports 868 MHz bands and antenna diversity
2x SX1255 radio front end is 433 MHz band with antenna diversity support
1x SX1257 and 1x SX1255, dual-frequency operation can be performed simultaneously
The IF of all modems can independently adjust the baseband bandwidth within the allowed radio range, such as ±400khz. Provides optimized firmware to optimize the settings of the SX1257/55 radio and performs real-time automatic gain control. As shown in the following block diagram:
Semtech SX1308 features:
Up to -139dBm sensitivity with SX1257 or SX1255 Tx/Rx front end
70dB continuous wave interference offset at 1MHz
Can work under negative signal-to-noise ratio
CCR up to 9dB
49x LoRa demodulator and 1x (G)FSK demodulator
Dual digital Tx and Rx radio front-end interface
10 programmable parallel demodulation paths
Dynamic data rate adjustment (ADR)
Semtech SX1308 Product Description
SX1308 is a constant frequency and uses a 6-pin SOT23 current-mode boost converter, so it is suitable for small, low-power applications. It is worth noting that the switching frequency of SX1308 is 1.2MHz, and small and low-cost capacitors and inductors with a height of less than 2mm can be used. Internal soft-start reduces inrush current and extends battery life. SX1308 has the function of automatically switching to pulse frequency modulation mode under a light load. SX1308 includes under-voltage lockout, current limit, and thermal overload protection to prevent damage in case of an output overload.
sx1308 module
Semtech SX1308 application areas:
Smart metering
Secure sensor network
Agricultural monitoring
I will talk about the relevant discussion and introduction of LoRa technology today. The development prospects of LORA are very impressive. What Jotrin will introduce to you today is only a small part of it. If you want to discuss more related issues about LORA technology, Please pay attention to the Lora column of our technical articles.
Ratings and Reviews
特殊な製品に関連する
-
GV7704-IBE3
Semtech
LBGA 169L 11MMX11MM > -
GS1671AIBE3
Semtech
Receiver 100Pin BGA > -
SX8651ICSTRT
Semtech
IC SCREEN CNTRL 12BIT 12WLCSP > -
GS6150-INE3
Semtech
SDI Reclocker Serial Interface 48-Pin QF > -
GS1662-IBE3
Semtech
SD/HD-limited transmitter without audio > -
UCLAMP1201T.TCT
Semtech
SLP1006P2 > -
SC4530WLTRT
Semtech
Conv DC-DC 3V to 30V Step Down Single-Ou > -
SC410AMLTRT
Semtech
2A EcoSpeed Step-Down Regulator with LDO > -
SC284ULTRT
Semtech
Conv DC-DC 2.9V to 5.5V Step Down Dual-O > -
SMDA24C
Semtech
ESD Suppressor TVS 24V 8-Pin SO Tube > -
SC604AIMLTRL
Semtech
MLPQ-16 > -
ECLAMP8052P.TCT
Semtech
COMMON MODE FILTER & ESD ; HT SUSA CODE: > -
DMG5802LFX
Semtech
DUAL N-CHANNEL ENHANCEMENT MODE MOSFET > -
SX8656IWLTRT
Semtech
4/5 WIRE RESISTIVE TOUCH ; HT SUSA CODE: > -
GS3490-INE3
Semtech
Bi-directional SDI device. Equalizer + c >



すべてのカテゴリ
.jpg)

